We are searching data for your request:
Forums and discussions:
Manuals and reference books:
Data from registers:
Upon completion, a link will appear to access the found materials.
Material:Ordinary tracing paper (in roll 37 cm wide, 100 g) Photocopy of the motif (enlarged to 200%) 1 ruler 1 cutter Paint for ceramic gold Soft brushes (n ° 4, 8 and 12) 2 round sticks (ø 15 mm, length 50 cm) Roller glue 1 small twist Fine satin ribbon
3 'CuttingCut a layer length of 90 centimeters.
20 'Reproduction of the motifPlace the layer on the photocopy and reproduce the pattern, centering it vertically. The rods were made by going up the line using the brush No. 12 used throughout its width. The leaves were traced by drawing the line from the stem to the tip, using the brush No. 8 used transversely. You will then use brush n ° 4 to make the small stems linking the leaves and the main stem. You will very easily clean your brushes by dipping them in solvent.
5 'DrillingDrill two holes in one of the rods 5 cm from each end.
10 'AssemblyPlace a strip of glue along the two ends of the layer on the wrong side. Place the sticks along the strips of glue and close the glued ends on the tracing so as to trap the sticks there. Be careful to place the pierced wand at the top of the pattern.
2 'InstallationHang your kakemono using the ribbon, tucked into the holes in the stick and whose ends you have tied.
20 tracing paper objects © Flammarion editions, 2003